Fixed - Echo J7 Cycle Computer Manual

: The magnet must pass within 2mm to 4mm of the sensor mark. If the gap is wider, the sensor will not trigger.

Attach the sensor to the fork and the magnet to a spoke. The distance between the magnet and sensor should be for accurate signal pickup. 4. Maintenance and Troubleshooting Battery Replacement:

: Press the MODE button to toggle between Km/H and Mile/H . Set Wheel Circumference : echo j7 cycle computer manual

Stores the highest speed achieved since the last reset. How to Reset Trip Data

Roll the bike forward in a perfectly straight line until the tire completes one full rotation and the valve stem is back at the bottom. Mark the ground at this second location. : The magnet must pass within 2mm to 4mm of the sensor mark

If the display is active but shows 0.0 speed while riding, check the alignment of the magnet and sensor. They may have shifted beyond the 4mm detection range.0;1bb;

Use a soft, damp cloth with mild soap to clean the screen. Avoid harsh abrasive cleaners or chemical solvents. The distance between the magnet and sensor should

Route the wire down your front brake cable. Wrap it loosely around the cable to prevent it from flapping or getting caught in the wheel spokes. Leave enough slack near the handlebars to allow the front wheel to turn fully. Step 2: Install the Sensor and Magnet

Used for securing the bracket and sensor. CR2032 Battery: The standard 3V coin-cell power source. 2. Step-by-Step Hardware Installation

Echo J7 Cycle Computer: The Ultimate Setup & Troubleshooting Manual